GlowbackLED Q&AAnswer
Jun 03, 2024 - 11:32 AM
All out products are constructed as best as possible to avoid any hot spots at full power.
the worst case scenario will be the panel etching which will be visible in our light panels if used as main source of light instead of back lighting. For those scenarios we can provide a diffuser to allow for an even light distribution.
there is also a slightly brighter aura around the edge of the panels as this is where the LEDs are located. Yet, this is normally visually dissipated when backbiting most translucent materials.
If your question is for one of our products in specific, please feel free to reach out to us to get you a better detailed answer.
the worst case scenario will be the panel etching which will be visible in our light panels if used as main source of light instead of back lighting. For those scenarios we can provide a diffuser to allow for an even light distribution.
there is also a slightly brighter aura around the edge of the panels as this is where the LEDs are located. Yet, this is normally visually dissipated when backbiting most translucent materials.
If your question is for one of our products in specific, please feel free to reach out to us to get you a better detailed answer.
